Monday I found a few cool designs I liked and the layout fit my plan. 2 Steps Taken to Reach Objective: Objective (s): Work on CEA and work in lab. List issues / Complications: 1 3 4 Me and Dylan worked on some ideas with the rear end. . I looked at a couple of designs for my car dealership. Tuesday I thought of a few Ideas like welding them to the support bars whenever we get them made. 2 Steps Taken to Reach Objective: Objective (s): Work in the lab on year long project think about or draw ideas for commercial project. List issues / Complications: 1 3 4 Me and Dylan took measurements to get the support bars made. I was trying to think of Ideas for engine mounts on the rear end for the body. We came up for a design on the rear end of the body to shave it down. Wednesday We got all the lines on and took it outside to cut. 2 Steps Taken to Reach Objective: Objective (s): Work in lab on year long project. List issues / Complications: 1 3 4 After it was cut the body mounts we had designed would work. We finished our design on the rear end body and started drawing the lines from the tape. Thursday We got one bar cut out. 2 Steps Taken to Reach Objective: Objective (s): Work in lab on year long project. List issues / Complications: 1 3 4 I started measuring the squares and got them lined up to be 18 in. Me and started to cut out the bars for the old engine attachment. I drilled holes and put nuts and bolts on to hold them together. Friday We got the bars cut and set in place to be center with the car. 2 Steps Taken to Reach Objective: Objective (s): Work in lab on formula and finish up the CEA designs. List issues / Complications: 1 3 4 I finished making the 18 x 18 square for Robotics. The bars were cut out and we cut new bars for new engine attachment.